Insignia Grampion Left Hand Hydro Shower Cabin 1200mm x 800mm Offset Quadrant Enclosure Unit

The newest Insignia hydro shower cabin to hit the market, this shower cabin will fit perfectly into any bathroom installation.

Water supply requirement: separate hot and cold inputs are required, each at a pressure of 1.5 - 3.5 Bar. NB: if the water pressure is below this range a twin negative head pump must be used to boost the hot and cold supply.

A pump must not be used on the output of a combi boiler.

Installation guidelines:

150mm clearance must be allowed for between the cabin roof and ceiling to allow adequate venting. It is essential that a fully qualified electrician install the unit in accordance with current regulations. The product requires hard wiring into the mains.

*Please note that due to manufacturer improvements slight differences can occur when compared to images used such as control panel but all features are generally the same and are normally improved upon as aresult in changes.