Insignia Angola 800mm Hydro Shower Cabin Enclosure Quadrant Corner Hydro Unit

The Insignia Angola hydro shower cabin enclosure boasts a host of features with that contemporary look for any modern bathroom.  This Hydro Shower Cabin is perfect to fit most bathroom cloakrooms or ensuite bathrooms

Product Features

• Fixed hand shower
• Internal mood lighting
• Fold down cabin seat
• Over head rain shower built into the enclosures roof
• Storage shelf with chrome rail
• 10 Hydro-massage Jets
• Built in FM Stereo
• 5mm Tinted Tempered Glass
• Bottom Drain
  
• Dimensions: 800mm x 800mm x 2200mm (WxDxH)
• Easy Glide Doors With Magnetic Closer
• Computer Controlled LCD Screen
• Mobile foot massage
• Hot and cold connections
• 12 month RTB parts warranty - Upgrade Available
• Hot and cold connections
• Can be connected to a combination boiler
• Low pressure water supply may require a pump. Minimum 1.5bar
• Requires 14/16 ltrs of water per minute flow rate
• CE Certified
• ISO9001 Approved
• Low pressure water supply may require a pump.
• We would recommend the Salamander ESP75 2.2 bar shower pump for use with this Shower
• Combi Boiler Compatible - will require a pressure equalising valve to ensure that balanced Hot & Cold water is supplied to the shower unit.
• Optional Fitting Kit - Comprises of: 2 x braided hoses, PTFE Tape, 1 x clear silicone, 2 x isolating valves and special adapted waste. Add this accessory pack to your order for a special online price. For More Info - Click Here.
• iShower Compatible - Check Here for Product Info not included as standard but is an optional extra.
  
• Optional ShowerGuard - Shower guard will protect your new investment permanently from limescale.  It also makes cleaning a lot easier and is water resistant making it easier to clean the glass, Any non-abrasive cleaner can be used Check Here for ShowerGuard Product Info
• Optional PEV - Pressure Equalising Valve is designed to Balance the hot & cold water pressures for use with Combi Boilers to ensure your shower is protected against un-balanced hot & cold water pressures.  Check Here for PEV Product Info

Installation Manual

Checkout the Latest Insignia Installation Manuals - Available to Download at the Insignia Website

Water supply requirement: separate hot and cold inputs are required, each at a pressure of 1.5 - 3 Bar. NB: if the water pressure is below this range a twin negative head pump must be used to boost the hot and cold supply.

Please note you must register your purchase on Insignia's Website this will ensure you receive your warranty and a speedy resolution should any problems ever arise.

A pump must not be used on the output of a combi boiler.

Installation guidelines:

150mm clearance must be allowed for between the cabin roof and ceiling to allow adequate venting. It is essential that a fully qualified electrician and fully qualified plumber install the unit in accordance with current regulations. The product requires hard wiring into the mains.

*Please note that due to manufacturer improvements slight differences can occur when compared to images used such as control panel but all features are generally the same and are normally improved upon as aresult in changes.  This model does not have thermostatic water control valves  we advise the installation of a pressure equalising valve to help regulate the hot and cold water pressures. (this will help if/when someone turns on the cold/hot water elsewhere)